Cequent Performance Products REESE Dual Cam HP Instructions D'installation page 3

4. Using a C-clamp suitable to accommodate your trailer frame height and the Dual Cam HP frame plate, temporarily clamp the
Dual Cam HP cam arm assembly to the trailer frame and Dual Cam HP frame plate as shown in figure 6 for Trunnion style
Weight Distribution kits, for Round Bar style Weight Distribution Kits, follow the dimensions in figure 7.
5. Position the Frame Plate at the dimension shown for your type Weight Distribution Kit (Trunnion Style or Round Bar).
Measure from the mark on the ball coupler to the center of the cam arm pivot bolt as shown in figure 6 or 7. If the frame plate
interferes with any part of the trailer frame, the orientation can be changed by switching sides, see figure 8 for optional Frame
plate orientation – maintain the same coupler center to cam arm pivot dimension regardless of frame plate orientation.
6. Position the Chain Hanger temporarily at the dimension shown as a starting point. (Upon hook-up, the Hanger position must
be adjusted to be sure the chain is vertical before towing). Tighten the Chain Hanger bolt shown in figure 2 against the frame.
Trunnion Style Set Up Locations
Figure 6 – Cam Arm Approximate Locations for Trunnion Style Weight Distribution kits
Round Bar Set Up Locations
Figure 7 – Cam Arm Approximate Location for Round Bar Weight Distribution kits
The Measurements in figures 6 & 7 are guidelines, adjustment of the cam arm length via the adjustment nut (Figure 5) may be
required after hookup in later instructions of this manual Cequent Performance Products, Inc. is not responsible for damage
incurred due to disregarding any part of this manual.
©
2010 Cequent Performance Products, Inc.
Installation Instructions
REESE Dual Cam HP
High-Performance Sway Control
CAUTION:
Sheet 3 of 8 26002IN 07-30-10
Form: F205 Rev A 5-6-05
Rev. H