Troubleshooting; Technical Data - Kesseböhmer FREEslide eTouch Instructions De Montage

9. Troubleshooting

10. Technical data

Item 72071
Software version
SW 09
Date DMY
15615
F2013292
Consec. no.
Lfd.Nr. 248 0062
Checker
Manufacturing order
72072
V1-13072015
24415
F2014300
Lfd.Nr. 350 0136
Interference Cause
Not working Mains voltage not present
Plug connections have
no contact
After 2 minutes of
permanent operation - stop
for 8 minutes
Unable to perform Push button sender / drive
reference run unit coordination not
carried out
Battery in push button
sender empty, not present
or wrongly inserted
Reference run starts Force setting of fitting does
but is not completed not match flap weight
Reference run Power failure
restarts
NOTE
» Contact your specialist dealer if the fitting is still defective after performing the
described remedial measures or other interferences arise.
FREElift eTouch
72071 (for FREEfold, slide & swing) &
72072 (for FREEflap)
Voltage / Frequency / Current strength
Drive power consumption
Protection class (with power supply
included in scope of delivery)
Protection class (with power supply
not included in scope of delivery)
Emission sound pressure level
Radio frequency
Radio remote control battery
Standby power
NOTE
» The drive may only be operated with safety low voltage in accordance with the
marking on the device.
Remedy
Check whether power plug has
been inserted
Check all plug connections
for proper contact
Wait for 8 minutes
Perform push button sender
coordination, see chapter
4.1 Teach in push button
sender
Insert new battery or check for
correct installation position,
see chapter 7.3 Battery
change
Perform force setting as per
point 12 of the Free flap fitting
installation instructions
Perform reference run, see
chapter 5.1 Initiating a new
reference run
100 - 240 V AC / 50 - 60 Hz / 1.3 A
24 V DC / 2.5 A
60 watts
2
3
< 70 dB(A)
2.4 GHz
CR 2032 Lithium button cell, 3 V
1 Watt
en
49/160