Usage Restriction; General Installation Reference; Programming - Kesseböhmer FREEslide eTouch Instructions De Montage

3. General installation
reference

4. Programming

2.5 Usage restriction

This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
More information can be found on the Internet at:
http://support.kesseboehmer.de/freelift-etouch
NOTE
A prerequisite for problem-free programming and functionality of the electric drive
is accurate setting of the load bearing capacity of the two mechanical basic fittings
to the individual flap weight. The fittings must be set such that the flap remains
in the position in which it is released from an opening angle of about 25-30°
(no dropping, no independent swivelling upwards).
Upon delivery from the manufacturer's, the drive units can be installed regardless of
pairing or assignment to the push button senders.
It must always be ensured that the power plug is accessible, also after the wall unit
has been fitted.
Upon delivery from the manufacturer's, the push button senders are not taught in.
Individual push button senders can be taught in or removed.
» Before programming the push button senders, insert batteries or remove the
inserted insulating strip, see picture section on page 151.
Programming procedure
4.1
4.2
4.3
4.4
NOTE
An activated menu item remains active for 30 seconds, then the setup menu
is automatically exited.
Acoustic feedback
A signal is emitted after every action.
Confirmation
A step that was learned during teach-in
or programming has been confirmed.
+
5.1
5.2
7.2
45/160
en