Front Panel Explanations - Atlantis Land OnePower A03-PS651 Mode D'emploi

5. When UPS is
seconds until switch off (Switch off UPS, must turn off the equipment
which connect to UPS, Then press POWER button).
IMPORTANT NOTICE: Plug the UPS into the wall outlet to charge the UPS for
over 10 hours before using the UPS.
IMPORTANT NOTICE: Before connect with equipment power supply line,
please count the total equipment
output watt. If it higher
equipment, or UPS will lock under backup power condition (No output
of UPS, display OVERLOAD or FAULT).

1.8 Front Panel Explanations

On the front panel You can found 3 LED for an easy diagnostic.
LED
Main Switch(4)
NORMAL(1)
operating,
than UPS
Information
To Control on/off the UPS when Utility is normal.
To enable "DC-Start" Function when Utility fails. (To enable
DC Start properly, you are recommended to connect <80%
output load with the UPS only). P.S. Make sure the
computer connected to the UPS is switched on before
enable the "DC-Start" function. You are not recommended
to add some other computer or peripherals after DC-Start
function is activated.
Green LED remains standstill when Utility is normal.
OnePower Line Interactive UPS (EN)
press POWER button and hold 3
watt. The number must lower than UPS
output watt,
A03-PS651
please reduce some
Pag. 21