Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Donnée techniques
Traitement de signaux analogique
Filtre anti-résonnance, limiteur de pointe
adaptatif
Limiter threshold50 W / 4 ohms
Système d'enceinte
Enceinte complète double cône 8"
(200 mm), , caisson reflex de graves
bass reflex enclosure
Alimentation électrique
Tension secteur (selon le modèle): 100, 120,
230, ou 240 V, 50-60 Hz Puissance absorbée :
max. 100 W
Mains fuse
Size: 5 x 20 mm
For 230 and 240 V models: T 1A L 250V
For 100 and 120 V models: T 2A L 250V
Plage de température de fonctionnement
0...35 °C
Coffret électrique
12 mm (0.47") birch plywood
Peinture
Acrylique à l'eau, finition noire type
éclaboussures rbased acrylic, black spatter
finish
Dimensions and weight
Dimensions
260 mm (10.2") de haut
205 mm (12.8") de large
235 mm (9.25") de profondeur
Poids
6.1 kg (13.5 lbs)
Notes
Options configurable by internal jumpers (refer
modification to qualified personnel):
·
9 V phantom power for channel 1.
Caution: Phantom power may damage external
equipment. Read the notes in the operating
instructions.
·
Low-gain option (more headroom) for mic input
·
Deactivation of 48V phantom power for mic input
DEFINITIONS
Rated conditions
·
Nominal input voltage at input under test
·
master fully clockwise
·
high / low and colour off
·
bass / middle / treble / pan centered
·
gain of unused inputs and efx level fully anticlockwise
·
gain of input under test adjusted to nominal output
voltage at line out. (This condition corresponds by design
to the rated output power.)
Nominal input voltage: Standard condition for specifications,
if not stated otherwise.
Minimum input voltage: Input voltage required for nominal
output with maximum gain and volume settings.
Maximum input voltage: Input voltage that does not cause
distortion more than rated THD+N, suitable control settings
provided.
Nominal output voltage or power refers to rated conditions.
THD + N: Total harmonic distortion + noise, input
voltage reduced by 10 dB after setting up rated
conditions.
Signal / noise ratio: Ratio of output voltage at rated
conditions to output noise voltage with input shorted.
Equivalent input noise voltage: Noise voltage at loudspeaker
terminals divided by gain of amplifier. Input shorted after
setting up rated conditions.
Residual noise: Output noise with minimal gain and volume
settings.
Adaptive limiter: Adaptive with respect to power supply.
Maintains constant headroom regardless of power supply
fluctuations.
General: Signal voltages are RMS values. Test signal sine 1 kHz
sine unless stated otherwise. Noise measured from 20 Hz to
20 kHz. Noise stated for a specific input implies that all other
inputs are not used. Sound pressure level (SPL) based on louds-
peaker specification by manufacturer.
Specifications and appearance subject to change without
notice.
TD20160511 (Compact 60
)
3
25
Publicité
Table des Matières
