Hama TH-140 Mode D'emploi page 5

Note
• The day of the week is automatically selected when you set the date manually.
• The settings will automatically close if there is no entry for 20 seconds. The
settings that were made up to that point are not saved!
5.2 Setting and using the alarm function
• In normal time mode, press the MODE button (2) once to set the alarm function.
ALM is shown on the display.
• Press the SET button (3) for approximately 2 seconds. The hours display begins
to ash.
• Press the UP button (4) or the DOWN button (5) to select the hour for the alarm
time and con rm your selection by pressing the SET button (3). The minutes
display begins to ash.
• Repeat the process to set the minutes for the alarm time. Then con rm the process
with the MODE button.
• Press the MODE button (2) twice to go to the start display.
• To activate the alarm function, you must press the MODE button (2) once to
switch to ALM mode. If you press the UP button (4) once, the bell symbol
appears on the display and the alarm is set.
• If you press the DOWN button (5) during the alarm, the alarm will be interrupted
for 4 minutes and then go off again. The (
• If no button is pressed, the alarm automatically switches to the snooze function;
the alarm will be likewise interrupted for 4 minutes and then go off again. The (
:
and ) symbol ashes.
• Press any button (except the DOWN button) to stop the alarm/snooze function.
Note
• When the alarm function is activated, the alarm melody sounds daily at the
selected time.
• To completely deactivate the alarm function, press the MODE button (2) and
then press the UP button (4) three times until the
shown on the display. Press the MODE button (2) twice to return to the start
display. is no longer shown on the display.
5.3 Maximum and minimum value (MAX/MIN)
• The base station automatically stores the maximum and minimum indoor
temperature and humidity values.
• Repeatedly press the UP button (4) to switch between the current temperature,
maximum temperature (MAX) and minimum temperature (MIN).
• Press and hold the UP button (4) for approximately 2 seconds to reset the stored
maximum and minimum values.
5.4 Hourly reminder alarm
• If you activate the hourly reminder alarm, a signal will sound every hour on
the hour.
• Press the MODE button (2) once to go to alarm mode (ALM).
• Press the UP button (4) twice to activate the hourly reminder alarm.
• If you press the UP button (4) a third time, both the alarm you have set (to go off
at a particular time) and the hourly reminder alarm will be activated. Press the
button a fourth time to deactivate both alarms.
appears on the display if the hourly reminder alarm is activated.
•
appears on the display if both the alarm you have set and the hourly
reminder alarm are activated.
4
:
and ) symbol ashes.
symbol is no longer