Warning - Batteries; Getting Started - Hama TH-140 Mode D'emploi

Warning – Batteries
• Do not charge batteries.
• Do not throw batteries in a re.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow them to enter the
environment. They can contain toxic, environmentally harmful heavy metals.
• Immediately remove and dispose of dead batteries from the product.
• Avoid storing, charging or using the device in extreme temperatures and
extremely low atmospheric pressure (for example, at high altitudes).
Warning – Button cells
• Do not ingest battery, risk of burns due to dangerous substances.
• This product contains button cells. If swallowed, the button cell can cause
severe internal burns within just two hours and lead to death.
• Keep new and used batteries out of the reach of children.
• If the battery compartment does not close securely, stop using the product and
keep it out of the reach of children.
• If you think that batteries were swallowed or are in a part of the body, seek
medical assistance immediately.

4. Getting started

Open the battery compartment cover (6), remove the contact breaker and then
close the battery compartment cover (6). The thermometer is now ready for use.
4.1 Base (7)
To stand the product, the base (7) must be pulled out beneath the battery
compartment cover (6) and folded over.
5. Operation
5.1 Setting the date/time/time format
• After removal of the batteries' contact breaker, the normal time is displayed in
12-hour format and a melody signals that the product is ready for use. (Normal
time mode)
• Press the UP (4) or DOWN button (5) to switch between the 12 and 24-hour
formats.
• Use the UP button (4) or DOWN button (5) to select the desired format.
• Then press the SET button (3) to make the following settings:
• Hours
• Minutes
• To select individual values (hours/minutes), press the UP button (4) or the DOWN
button (5) and con rm each selection by pressing the SET button (3).
• Then complete the process using the MODE button (2).
• To change the set time, you must press the SET button (3) for 2 seconds; you can
then continue as described above.
• Pressing the MODE button (2) twice takes you to the date/year/month settings. To
enter the values, hold the SET button for approximately 3 seconds.
• To select individual values, press the UP button (4) or the DOWN button (5) and
con rm each selection by pressing the SET button (3).
• To con rm all your settings and return to the start display, you must press the
MODE button.
Note – Input
• Hold the UP button (4) and the DOWN button (5) to select the values faster.
• A selected item will ash to indicate that it can be set.
3