Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9
USER CONFIGURATION
7
Press and hold '7' until a double signal sounds. The LED will illuminate when performing the following
actions. Listen to tone signals!
For example:
9
8
7
6
• Enter the Manager Code
1
2
3
4
• Enter 1, 2, 3, 4, 5, 6, 7, 8, 9, 0 to stop
Double signal
Single signal
10
REPLACING THE BATTERY
8
5
4
5
6
7
8
= User active
= User not active
9
0
If the lock emits a series of audible tones when
opened the battery is almost exhausted and
must be replaced immediately.
You may only use fresh 9V ALKALINE Duracell,
Duracell Industrial, Procell or Energizer alkaline
block batteries.
To insert a battery loosen the screw (if present)
and slide the cap off the unit as shown. Remove
the used battery and connect one fresh battery
to the battery clip. Align cap in the little track
of the housing and slide back on. Be careful not
to pinch the battery cable. If present, tighten
screw firmly.
www.m-locks.com
Publicité
Table des Matières
