Important Instructions - M-LOCKS E-Pass EP1750 BM Manuel Utilisateur

1

IMPORTANT INSTRUCTIONS

• Before using the lock, please read the instructions for use carefully.
• The instructions for use only relate to the lock itself and not to how to operate the cabinet.
• Ensure that you only program the lock when the door is open.
• After changing the code, always try the code several times with the door open.
• Only after several positive function tests (opening / closing) the door may be closed.
• Each key entry is confirmed by an audible tone and visual signal. These signals are not referred to in
the description that follows.
• Acoustic signals are always accompanied by the same optical signals.
• You have a maximum of 10 seconds for each key entry. If you do not make an entry via the keypad
during this period of 10 seconds, the entry procedure will automatically abort. You must then start
again from the beginning.
• After entering a valid code, a double signal sounds. An invalid entry will trigger a long tone.
• After entering an invalid code the first attempt; wait 20 seconds before entering the code again.
• If the code is entered incorrectly on four consecutive occasions the keypad and the lock will be
disabled for 5 minutes. During this period, the LED will flash every 10 seconds and a long tone
sounds when attempting to make an entry. Entering an incorrect code on two further occasions
after the keypad has been re-enabled, will trigger a new keypad lock-out period of 5 minutes. After
entering a valid code you have four new occasions to enter the code and open the lock.
• The lock only works with 6-digits codes.
• At the time of delivery, the lock is set to the standard Manager Code 1-2-3-4-5-6. Change this
code immediately to your own choice of Manager Code. Do not use personal or other simple data
which can easily be found out for your Manager Code.
• If needed, the owner of the Manager Code can add up to 9 user codes.
• The Manager code can only be changed by the manager. User codes can only be changed by the
user himself.
• User codes can be deleted but not changed by the manager. Users can change their code, but not
delete their code.
The manager code can only be managed by the manager himself.
• Always keep the code stored carefully and protect it against improper use by unauthorized
persons.
• Make sure the code is protected by entering. Don't let anyone look.
• Depending on the used lock / keypad and the way the lock is installed, there are several ways to
open and to close a cabinet. Please contact your cabinet supplier for more information about your
specific situation.
!
Caution! Don't forget your code, otherwise the lock can not be used anymore!
4 www.m-locks.com