Bestop 77332 Instructions D'installation page 26

Section 21
Route Wire Harness; Plug CHMSL Wire Harness Connectors Together
Step 1
Secure 29' Wire Harness
under bed rail with 2"
pieces of Foam Tape
1"
Step 1
Route the 29' Wire Harness from the front of the
vehicle bed to the rear, underneath the bed rail,
and through each of the three clamps. )See De-
tail) Attach the wire to the underside of the bed
rail using 2" pieces of the Foam Tape #593.51.
Run the wire to just 1" past the rear clamp.
P26 - 77332 Rev. D 0121
Detail
Hardware
Foam Tape
Part #595.31
2" Pieces
Installation Instructions - Supertop for Trucks
Route Wire Harness
under bed rail
Step 2
Step 2
After routing the 29' Wire Harness,
plug the 2-conductor connectors at the
ends of the CHMSL Wire Harness and
the 29' Wire Harness together.
NOTE:
connectors before folding the top
down.
Page 26
You must unplug these
© 2021 Bestop, Inc.