Product Disposal - Di4 Vapore Stiro Blue 2800 Manuel D'utilisation

TROUBLESHOOTING
PROBLEM
SOLEPLATE IS NOT
HEATING EVEN
THOUGH IRON IS
TURNED ON.
IRON DOES NOT
PRODUCE STEAM
SPRAY FUNCTION
DOES NOT WORK
STEAM JET AND
VERTICAL STEAM JET
FUNCTION DOES NOT
WORK
THE IRON LEAKING
WHITE STREAKS COME
THROUGH THE HOLES
IN THE SOLEPLATE

PRODUCT DISPOSAL

This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal
framework applicable in the European Union for the disposal and reuse of waste elec-
tronic and electrical devices. Do not dispose of this product in the bin, instead going to the
electrical and electronic waste collection centre closest to your home.
We hope that you will be satisfied with this product.
20
POSSIBLE CAUSE
Connection problem
Temperature control is in MIN
position
Not enough water in tank
Steam control is selected in
non-steam position.
Selected temperature is lower
than that specified to use with
steam.
Not enough water in tank
Steam jet function was used
very frequently within a short
period.
Iron is not hot enough
The temperature setting is too
low to produce steam.
The soleplate has a build-up
of scale because it has not
been self-cleaned regularly.
SOLUTION
check main power supply cable,plug and
outlet.
select adequate temperature
Fill water tank
Set steam control between positions of
minimum steam and maximum steam
(see "iron chart").
Select a higher temperature
Fill water tank
Put iron on horizontal position and wait
before using steam jet function.
Adjust to higher temperature to steam
ironing.Put iron in vertical position and
wait temperature indicator light becomes
fixed.
The variable steam knob must be set
on"0"position until the iron is hot.
Do the self-cleaning process. Remember
to do it at least every two weeks.