Dicota Stow Guide D'utilisation page 5

2. Establishing a connection between the mouse and the RF receiver
The following steps have to be carried out within 15 seconds if a success-
ful connection is to be established between the mouse and the RF
receiver. Ensure that the mouse is no further than 1.5 m away from the
RF receiver.
1.) Connect the RF receiver to any free USB port on your computer.
The Plug & Play function of your system will automatically detect that
a new device has been connected. The mouse will not yet be ready to
use at this stage.
2.) First, press the Connect button on the receiver that shown as step 1.
3.) Then, press the Connect button on the bottom side of the mouse
as step 2.
4.) After a few seconds your mouse will be ready for use.
First press the
receiver's ID button ...
1.
3. Sleep mode
The mouse will switch to power saving mode after 3 seconds while
working. If not used, it will power off automatically after 8 minutes to
extend battery life. The mouse will be activated again with one mouse
click.
Note on handling batteries
• Keep batteries out of children's reach.
• Do not mix old and new batteries or use different types of battery.
• Replace old or weak batteries promptly.
• Dispose of and recycle your old batteries in accordance with local
regulation
... then press the
transmitter's ID button
2.