Installation; Installation Precautions; Storage And Maintenance - Kenwood AS-IP70 Mode D'emploi

Installation

Installation Precautions

• Install this unit on a level, stable position. If this unit is installed on a bench or tabletop, be sure to confi rm the strength in advance.
• The magnetism generated from the speakers may produce color irregularities on the screen of a TV or PC in proximity. Install the speakers at
a distance from a TV or PC.
CAUTION
Observe the following cautions when installing the equipment including the AC adapter. Insuffi cient ventilation builds up heat inside them and
may cause malfunction or a fi re hazard.
• Do not place an object hindering heat radiation on the equipment.
• Do not lay the equipment on the rear or side panel or upside down.
• Do not cover the equipment with a cloth or place it on a carpet or cushion.
• Do not use the equipment in a poorly ventilated location.
• Leave a space of 50 cm or more above the equipment.
Install the equipment so that the power outlet is easily accessible. In the case of an abnormality, immediately unplug the AC adapter from the
power outlet. It is required to unplug the AC adapter to shut off the power supply to the equipment completely.

Storage and Maintenance

Do not leave this unit in the following locations.
• Place exposed to direct sunlight.
• Place with high humidity or excessive dust.
• Place exposed directly to the heat of heating equipment.
Precaution against condensation
When there is a large diff erence between the temperatures inside and outside this unit, water drops (dew) may be condensed inside the unit,
in which case this unit may malfunction. If this happens, leave this unit for a few hours until the condensation inside it dries up. Special care is
required against condensation when this unit is transported between locations with a large temperature diff erence or into a room with high
humidity.
When the equipment gets dirty
When the front panel or case is dirty, wipe with a soft, dry cloth. Do not use lacquer thinner, benzine, alcohol or contact revitalizer for these
chemicals may cause discoloration or deformation.
AS-IP70
6