Hiti P530D Mode D'emploi page 6

: Please make sure the power is off and the power cord is removed from the printer
before transportation.
: In the cause of dropping the printer during transportation, contact HiTi dealers or
service center for inspection of the printer. Using the printer with possible damage
without proper inspection may cause fire or electric shock.
＊ Attention: Do not dismantle or remodel the printer. Some sections of the printer
contain a high voltage or become very hot. Ignoring this warning may cause electric
shock, fire, or burns.
: Secure the power cable firmly while using.
: The thermal head reached high temperature during operation but it is normal. Do not
touch the thermal head by any case. Touch the thermal head may cause person injury
or damage of the printer.
＊ Attention: Touching the surface of the thermal head directly may cause damage
to the thermal head. Hard objects getting into the printer may cause the damage of
printer or result in malfunction. In such case, please do not use the printer while any
obstacle inside the printer.
: Do not attempt to service the printer beyond the instructions specified in this
document. In case of irrecoverable problem, please contact HiTi dealers or service
center.
: This product must be grounded at all time during operation, and always used with the
specified power cable only or the power cable accompanying this product. If the
product is used without grounding, and current leakage occurs, fire or electrical shock
may occur, and may also cause interference to radio, TV, and other similar electric
appliances signal receiving. If the proper ground is not available, please contact HiTi
dealers or service center.
5