Accessories; Packing And Unpacking; Setting To Work - Connection To The Power Supply - Nilfisk ALTO ATTIX 170 Mode D'emploi

Accessories

Various accessories are available; refer to the manufacturer's
accessory catalogue.
WARNING!
ATEX variant: refer to the manufacturer's sales
network.
WARNING!
Use only genuine accessories supplied and
authorized by the manufacturer.

Packing and unpacking

Dispose of the packing materials in compliance with the laws
in force.
Figure 3
Model A (mm)
ATTIX 170 1,300
ATTIX 170E 1,300
ATTIX 170 - M / H 1,300
11/2008
B (mm) C (mm) Kg
700 1,730 210
700 1,730 225
700 1,730 210
Setting to work - connection to the power
supply
WARNING!
■ Make sure that the vacuum cleaner is in perfect
condition before commencing work.
■ Before plugging the vacuum cleaner into the
electrical mains, make sure that the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
Make sure that the vacuum cleaner is off.
■ The plugs and connectors of the connection
cables must be protected against splashed water.
■ Make sure that connections to the electrical
mains and plug are correct.
■ Use the vacuum cleaners only when the cables
that connect to the electrical mains are in perfect
condition (damaged cables could lead to electric
shocks!).
■ Regularly check that the electric cable does not
show signs of damage, excessive wear, cracks or
ageing.
WARNING!
When the vacuum cleaner is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■ Only disconnect the cable from the electrical
mains by removing the plug (do not pull the
cable).
■ Only replace the electric power cable with one of
the same type as the original (HO7 RN - F); the
same rule applies if an extension is used.
■ The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualified
personnel.
5
ATTIX 170 / ATTIX 170 E
C328
I
GB
F
D
E