Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
Key
Can piercing lever
1
Cutter
2
Magnetic lid holder
3
Drive wheel
4
Bottle opener storage
5
Removable bottle opener
6
Knife sharpener
7

Cord storage

8
To Use Your Can
(A—E)
Opener
1 Plug the can opener into the
power supply.
2 Lift up the piercing lever.
3 Place rim of the can firmly
under the magnetic lid holder
and against the drive wheel.
4 Press the lever lightly down.
The self starting blade will
operate and pierce the can
and start cutting.. (It is not
necessary to hold the piercing
lever down during the cutting
action).
Note: It is recommended to
l
hold the bottom of large,
heavy or wide cans during the
cutting action.
This can opener will easily
l
open all standard-size cans.
5 Once the top of the can is
opened the motor will stop
automatically.
6 After cutting hold the can and
lift the lever up. The lid will be
retained by the magnet.
Using the Bottle
(G)
Opener
1 Remove the bottle
opener from the storage
compartment.
2 Place the bottle opener on
top of the bottle cap with the
metal blade under the rim of
the cap.
3 Lift up the end of the bottle
opener to remove the bottle
cap.
English
Using the Knife
Sharpener
1 Place the cutting edge of the
knife in the slot located on the
back of the can opener.
2 Draw the knife blade through
the slot several times.
NOTE: This sharpener will not
l
sharpen serrated knives.
Take care not to allow the
l
knife to cut into the body of
the can opener.
Cord Storage
Use the compartment at the
back to store the cord when not
in use.
Care and Cleaning
(F)
1 Unplug the appliance from the
power supply before cleaning.
2 Lift the lever and remove.
3 Wash the lever in hot soapy
water and dry thoroughly.
Dishwashing is not advised.
4 Replace the lever.
5 Wipe over the body with
a damp cloth and dry
thoroughly.
IMPORTANT INFORMATION
FOR CORRECT DISPOSAL
OF THE PRODUCT IN
ACCORDANCE WITH THE
EUROPEAN DIRECTIVE ON
WASTE ELECTRICAL AND
ELECTRONIC EQUIPMENT
(WEEE)
At the end of its working
life, the product must not be
disposed of as urban waste.
It must be taken to a special
local authority differentiated
waste collection centre or to
a dealer providing this service.
4
(H)
8

Publicité

Table des Matières
loading

Table des Matières