Noise And Vibration - Flex GE 5 Notice D'utilisation

harm. Some examples of these chemicals
are:
– Lead from lead-based paints.
– Crystalline silica from bricks, cement,
and other masonry products.
– Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending upon how often you do this type
of work. To reduce your exposure to these
chemicals:
– Work in a well-ventilated area.
– Work with approved safety equipment,
such as dust masks that are specially
designed to filter out microscopic
particles.
– Avoid prolonged contact with dust from
power sanding, sawing, grinding, drilling,
and other construction activities. Wear
protective clothing and wash exposed
areas with soap and water. Allowing dust
to get into your mouth or eyes or to lie on
the skin may promote absorption of
harmful chemicals.
Damage to property!
The mains voltage and the voltage speci-

fications on the rating plate must corres-
pond.

Noise and vibration

NOTE
Values for the A-weighted sound pressure
level and for the total vibration values can be
found in the "Technical specifications" table.
The noise and vibration values have been
determined in accordance with EN 60745.
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured
in accordance with a standardised test
given in EN 60745 and may be used
to compare one tool with another.
8
It may be used for a preliminary assessment
of exposure. The declared vibration emis-
sion level represents the main applications
of the tool. However if the tool is used
for different applications, with different
accessories or poorly maintained,
the vibration emission may differ.
This may significantly increase the expo-sure
level over the total working period.
However if the tool is used for different
applications, with different accessories
or poorly maintained, the vibration emission
may differ. This may significantly decrease
the exposure level over the total working
period. Identify additional safety measures
to protect the operator from the effects
of vibration such as: maintain the tool and
the accessories, keep the hands warm,
organisation of work patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
GE 5/GE 5 R/GSE 5 R