GMC GMC18CS Mode D'emploi page 13

Troubleshooting
Problem
Machine will not start
Blade does not reach full speed
Poor cutting
Vibration or abnormal noise
636575_Z1MANPRO1.indd 13
Possible Cause
Battery not charged
Battery fault
Switch fault
Motor fault
Battery low charge
Tool is overheating
Blade teeth worn
Blade damaged
Incorrectly fitted blade
Loose blade
Blade vibrating
Other part of tool has worked loose
Accessory incorrectly fitted or loose
13
Possible Solution
Charge battery
Replace battery
Contact authorised service centre to repair
Contact authorised service centre to repair
Charge battery
Switch off the tool and let it cool down to room temperature.
Inspect and clean the ventilation slots
Replace blade
Replace blade
Re-fit blade
Tighten blade securing bolt
Re-tighten blade securing bolt
Re-tighten
Correctly fit accessory
GB
13/01/2016 15:14