Taurus Alpatec TALLIN 600 Mode D'emploi page 15

- When the room temperature is higher than
the selected temperature, the heater will stop
heating.
PROGRAM SELECTION:
- Press (3) to select the program desired.
- Press (4) or (5) to select running mode and
press (3) to confirm.
- Free
- Daily
- Weekly
PROGRAM SETTING:
FREE PROGRAM:
- Chose the desired temperature using the but-
tons (4) and (5) and wait until the indicator stops
flashing.
- Press (3) continuously until the
screen.
- Press (4) or (5) to select the timer length in 30
minutes incremets. Maximum 24 hours.
- - The time programmed or remaining time will
appear on the display.
- Press continuously (3) to exit timer mode,
until the disappeared.
DAILY PROGRAM:
- Chose the desired temperature using the but-
tons (4) and (5) and wait until the indicator stops
flashing.
- Select the appliance mode desired.
- Confort
and
- Economic and
- Defrost , program content displayed empty.
- Select temperature for each working mode:
- Press continuously (3) until
- Pres (4) or (5) to sed your comfort temperature
desired.
- Pres (3) to confirm and the
- Pres (4) or (5) to sed your economic temperatu-
re desired.
- Select the desired program (2).
- Press continuously (3) to enter program setting
until shows on screen.
- Time segment to be programmed flashes.
- Press (3) to select the mode desired
.
- Press (4) or (5) to move to the next or previous
time segment.
- Repeat the operation until set the 24 hours with
the desired mode.
WEEKLY PROGRAM:
- Select weekly program
- Press continuously (2) until (II) and (III) flashes.
-
- Select the desired program
(5) for the day that flashes.
shows on
- Once selected the program press the button (2)
- Repeat the operation until you complete the
schedule for every day of the week.
- Press (3) to complete the weekly program
settings.
SAFETY LOCK:
- The buttons will be locked after one minute
without press any button.
-
- Press (4) and (5) at same time to unlock
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
- Turn the appliance off, using the on/off switch.
- Unplug the appliance from the mains.
- Clean the appliance.
shows on screen.
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- When the appliance switches itself on and off
shows on screen.
repeatedly, for reasons other than the ther-
mostat control, check to ensure that there are
no obstacles that impede correct air entry or
expulsion.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
, or
does not start again seek authorised technical
assistance.
.
Will appear on the screen.
with (4) or