Hand-Held Transmitter Control Elements; Installing And Connecting The Mt200; Operating The Mt200; Using The Remote Control - Dometic WAECO MagicTouch MT200 Manuel D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
_MT200.book Seite 12 Montag, 19. Juli 2010 7:28 19

Hand-held transmitter control elements

Consult the supplementary sheet to find out in which vehicle types this radio remote
control is installed.
5
Hand-held transmitter control elements
The hand transmitter has the following control elements:
fig. 1, page 3
Designation
1
"Lock" button
2
"SET" button
3
"Unlock" button
4
LED indicator (blue)
6

Installing and connecting the MT200

NOTE
I
If you do not have sufficient technical knowledge for installing and con-
necting components in vehicles, you should have a specialist install the
radio remote control in your vehicle.
Use the red piercing connector for cables of up to 1 mm
piercing connector for cables of up to 1.5 mm to 2.5 mm
Refer to the vehicle-specific instructions in the supplementary sheet to
find out how to install and connect the MT200 in your vehicle.
7

Operating the MT200

7.1

Using the remote control

Observe the following instructions when you use MagicTouch:
To ensure the remote control functions properly, a interference-free connection
between the hand-held transmitter and the control unit is required.
Depending on where the control unit is installed, and the transmission power of
nearby sources of interference, the range is up to 20 m.
Each time the hand-held transmitter is used, it sends a new code (rolling code).
For this reason, the control unit might not recognise the hand-held transmitter
immediately if you use the hand-held transmitter too frequently without the con-
trol unit receiving the transmission signal. In this case, press the hand-held
transmitter another one to three times; after the third attempt at the latest, the
control unit will detect the hand-held transmitter again.
Locking the central locking system
Press the "Lock" button on the hand-held transmitter.
If the ignition is switched off, the hazard lights flash once to confirm.
12
MagicTouch MT200
Function
Locks the vehicle
Learns the hand-held transmitter
Unlocks the vehicle
Lights up when pressed
2
. Use the blue
2
.

Publicité

Table des Matières
loading

Table des Matières