cecotec Total Iron 7000 SteamPro Manuel D'instructions page 21

ENGLISH
WARNING: Always allow the device and especially its soleplate to cool completely down before
touching or handling it.
Steam ironing
Note: To lengthen the appliance's service life, it is suggested to use purified water.
Put the unit base on a stable, flat surface.
Open the water inlet cover, fill the water tank with water through the filling opening. Do not
exceed the MAX mark on the tank: 2L.
Place the iron on the thermal insulation stand of the unit base.
Connect the plug to a wall outlet, turn the temperature dial and the defaulted MAX steam rate
indicator will turn steady on. Choose between MAX and ECO steam rate, select the desired
steam rate for each garment according to your requirement. Make sure that there is enough
water in the tank.
Turn temperature dial to select the desired temperature setting depending on the garment's
fabric, the iron wills start heating up.
Ironing tips
Always check if the garment to be ironed has a label with ironing instructions and if they
have, follow them.
If the fabric consists of various kinds of fibers, always select the lowest ironing temperature.
Synthetic fibre and silk fabrics should be ironed on their inner side to avoid them from being
damaged.
Velvet and other textures that rapidly become shiny should be ironed in one direction with light
pressure applied. Always keep the iron moving.
Pure wool fabrics (100% wool) may be ironed with the steam iron. Use a dry cloth as a mat and
then select the corresponding fabric setting for ironing.
Never iron over zip, rivet in the cloth, this will damage the soleplate.
Before activating the clean function, make sure that the water in the tank is sufficient, and
prepare a high temperature-resistant container to be placed under the soleplate for holding
the dirty water sprayed from the steam hole of the soleplate during cleaning.
After a few minutes, the temperature indicator will turn off indicating the soleplate has
reached the selected temperature and the iron is ready to use with steam.
Press the steam trigger to activate steam ironing. Release it to stop.
Note: Water may drip during spraying steam function when the temperature is set at the low
settings.
Warnings:
Do not activate the steam button when the iron is placed on the unit base to avoid being
scalded by steam.
After ironing, remove the plug from the wall socket, the appliance will turn off and all the
21
TOTAL IRON 7000 STEAMPRO / STEAMPRO TOTAL IRON 7200 TITAN / TOTAL IRON 7500 TURBOSLIM
05500_05503_05504_Total Iron 7000_7200_7500_Manual_YV01191106.indd 21 6/11/19 17:06