Scan Mode Settings; Voice Function - Midland G18 Guide D'utilisation

2. Turn the Encoder knob until "TOT" is displayed;
3. Push ENT to enter the function;
4. Turn the Encoder knob and set a timer from 30 to 270 seconds.
5. Confirm your selection with ENT.

SCAN mode settings

Press MENU and then rotate the Encoder knob. The display will show
"SCANS".
Press ENTER and then rotate the Encoder knob to choose the type of
Scan (TO/CO/SE).
Confirm your selection with ENT.
TO - Time-operated Scan
Whenever a signal is detected, the radio will suspend the scan for 5 se-
conds, and then will continue to scan even if the signal is still present.
CO: Carrier-operated Scan
Whenever a signal is detected, the radio will stop scanning. It will resume
to scan once the signal will disappear.
SE: Search Scan
The radio will stop scanning and exit the Scan mode once detected a
signal.

VOICE function

With this function, you activate a voice that informs you about any opera-
tion/selection you are doing.
To activate it, follow these steps:
1. Press the MENU button;
2. Turn the Encoder knob until "VOICE" is displayed;
3. Push ENT to enter the function;
4. Turn the Encoder knob to activate/deactivate the function: "ON" (to
activate it), or "OFF" (to deactivate it);
5. Confirm your selection with ENT.
Midland G18 instruction guide | 41