Important - Bestway Steel Pro MAX Manuel Du Propriétaire

Masquer les pouces Voir aussi pour Steel Pro MAX:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NOTE:
Drawings for illustration purpose only. May not reflect actual
product. Not to scale.
Pool Maintenance
If you do not adhere to the maintenance guidelines below, your health
might be at risk, especially that of your children.
Using chemical tablets (not included):
NOTE:
Chemconnect or Chemical Floater must be used when you
perform chemical maintenance with tablets. Your purchased item may not
include any of those dispensers, in this case you can
our website www.bestwaycorp.com or at the nearest pool dealer.

IMPORTANT:

Don't use granulate tablets or throw the
tablet directly in the water. The chemicals can deposit on the bottom,
damage the material and discolor the PVC.
Using chemical liquid (not included):
IMPORTANT:
Add chemical liquid in small doses and in
the center of the pool to avoid direct contact between the chemicals
and the PVC surface. Direct contact can damage the material and
discolor the surface.
NOTE:
Remove the chemical dispenser from pool when the pool
is in use.
IMPORTANT:
After performing chemical maintenance and
before using the pool, use a test kit (not included) to test the water
chemistry. We recommend maintaining your water according to the
following table.
TEST
pH value
Cyanuric acid
Free chlorine
Chlorine compound
Algae
Calcium hardness
NOTE:
Damage resulting from chemical imbalance is not covered by
the warranty. Pool chemicals are potentially toxic and should be handled with
care. There are serious health risks from chemical vapors and the incorrect
labeling and storage of chemical containers. Please consult your local pool
supply retailer for more information about chemical maintenance. Pay close
attention to the chemical manufacturer's instructions. Pool damage resulting
from misuse of chemicals and mismanagement of pool water is not covered
by the warranty.
purchase it by visiting
IDEAL VALUES
7.4 – 7.6
30 – 50 ppm
2 – 4 ppm
0
None visible
200 – 400 ppm
IMPORTANT:
Over usage of chemicals can discolor the printing and
all points of the pool material. It can also damage the structure of the pool
liner.
To keep your pool clean:
1. Contact your local pool supply shop for advice and purchase of chemicals
and pH kits. One of the most important factors to increase the life of the
liner is to keep continuously clean and healthy water. Please strictly follow
the instructions from professional technicians for the water treatment
through the use of chemicals.
2. Locate a bucket of water next to pool to clean users' feet before entering
pool.
3. Cover the pool when not in use.
4. Skim pool regularly to avoid settled dirt.
5. Check and wash the filter cartridge regularly.
6. Gently clean any scum from below the top ring with a clean cloth.
7. Please be careful in case of rain water, kindly check that the water level is
not higher than the expected. If so, YOU HAVE TO DISCHARGE THE
EXCESS WATER.
8. If it rains, check that the water level is not higher than the specified level. If
water exceeds the specified levels, drain the pool to the specified level.
Proper maintenance can maximize the life of
your pool.
During the season of use of the swimming pool, the filtration system must be
necessarily put into service every day, enough time to assure at least a
complete renewal of the volume of water.
NOTE:
The pump is used to circulate the water and to filter small
particles. In order to keep your pool water clean and hygienic, you must also
add chemicals.
Repair
In the event of a leak, patch your pool using the underwater adhesive
repair patch provided. You can find the instructions in FAQs on the
support section of our website, www.bestwaycorp.com.
Dismantling
1. Unscrew the drain valve cap on the outside of the pool counter clockwise
and remove.
2. Connect the adaptor to the hose and put the other end of the hose in the
area where you are going to drain your pool. (Check local regulations for
drainage by-laws).
3. Screw control ring of the hose adaptor clockwise onto the drain valve. The
drain valve will be open and water will start to drain automatically.
ATTENTION:
ring.
4. When draining is finished, unscrew the control ring to close the valve.
5. Disconnect the hose.
6. Screw the cap back onto the drain valve.
7. Air dry pool.
ATTENTION:
Storage and Winterization
1. Please remove all the accessories and spare parts of the pool and store
them clean and dry.
2. Once pool is completely dry, sprinkle with talcum powder to prevent pool
from sticking together, fold pool carefully. If pool is not completely dry, mold
may result and will damage the pool liner.
3. Store liner and accessories in a dry place with a moderate temperature
between 5ºC / 41ºF and 38ºC / 100ºF.
4. During the rainy season, pool and accessories should be stored as per
above instructions also.
5. Improper draining of the pool might cause serious personal injury and/or
damage to personal property.
6. We strongly recommend the pool is disassembled during the off season
(winter months). Store in a dry location out of children's reach.
NOTE:
If your purchased pool set do not have any circulation system,
you can purchase separately. But please make sure the equipment can turn
over total volume of pool water no less than once every 12 hr. You can check
the water capacity on packaging to select suitable circulation system. Pump
provided for the circulation of water shall be tested by a Nationally
Recognized Testing Laboratory and certified to conform to UL1081.
Also make sure the selected suction outlet sold with the pump should be
tested by a Nationally Recognized Testing Laboratory and certified to conform
to ASME/ANSI A112.19.8 or its successor standard ANSI/APSP-16, in order
to prevent suction entrapment.
12
Water flow can be controlled with the control
Do not leave the drained pool outside.

Publicité

Table des Matières
loading

Table des Matières