Publicité
Les langues disponibles
Les langues disponibles
g) Attach upper windshield to the machine by following instructions below.
1.
Make sure that both upper clamps are at the same height.
2.
Hold the upper windshield horizontally and slide it down by ensuring that both upper
pivot cylinder adaptors are going through the upper pivot as per drawing #1.
3.
Pull gently on the windshield as per drawing #2 towards the front of the vehicle for the
upper pivot to slide to the end onto the upper pivot cylinder adaptor.
4.
Lower the windshield as per drawing #3 and the upper pivot will catch the second
upper pivot cylinder adaptor.
5.
Adjust the height of the upper clamp first by ensuring the overall leveling.
6.
Tighten all screws regarding the upper pivot.
Adjust the height of the clamp to the lower pivot and slide arm and use 'T' knob to lock
7.
in place. Drawing #4 shows the position you should have when windshield is closed.
8.
Tighten all remaining screws and nuts.
To operate the tilt mechanism:
Simply loosen both 'T' knobs (without removing them) and push on the upper windshield from the
inside of the cab until the desired position is reached. Then tighten knobs. Note that there are 3 pre-
determined positions on the slide arm; closed, half-opened and fully-extended.
The tilt mechanism is designed for cooling the airflow in warm temperatures.
Note that any open positions are designed for low-speed operation ONLY.
At high speed riding or when transporting the vehicle, the windshield must be closed.
To remove the upper windshield:
Remove both 'T' knobs and follow reverse instructions 4, 3 & 2 of step #g).
2. Maintenance and Care
Tighten all hardware after first use and periodically thereafter.
Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. DO NOT SCRUB or use
To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol, then wash and rinse. DO
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual hazing, loss of light
- Fantastik1
- Joy2
Failure to follow these installation instructions completely may void any warrantable components and result in product damage or personal
injury.
2630 - Installation instructions for Polaris Ranger 400 full tilt windshield revision 01
Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
transmission and coating delamination.
Compatible Cleaning Agents
Aqueous Solution of Soaps and Detergents
- Neleco-Placer
- Hexcel, F.O. 554
CLEANING:
brushes or squeegees.
NOT USE GASOLINE.
- Windex5
- Formula 4091
- Lysol3
Drawing #4
- Pine-Sol4
- Mr. Clean2
WWW.KOLPIN.COM
Drawing #1
Drawing #2
Drawing #3
- Top Job2
3
Publicité
