Electrolux GT327 Notice D'utilisation page 59

Problem
The lid doesn't close com‐
pletely.
The lid is difficult to open.
The lamp does not work.
The compressor operates
continually.
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem‐
perature.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Food packages are block‐
ing the lid.
There is excessive frost.
The lid gaskets are dirty or
sticky.
The valve is blocked.
The lamp is defective.
Temperature is set incor‐
rectly.
Large quantities of food to
be frozen were put in at
the same time.
The room temperature is
too high.
Food placed in the appli‐
ance was too warm.
The lid is not closed prop‐
erly.
The ActionFreeze function
is switched on.
The lid is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The ActionFreeze function
is switched on.
The temperature regulator
is not set correctly.
ENGLISH
Solution
Arrange the packages in
the right way, see the stick‐
er in the appliance.
Eliminate excess frost.
Clean the lid gaskets.
Check the valve.
Refer to "Replacing the
lamp".
Refer to "Operation" chap‐
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food to cool to room
temperature before storing.
Check if the lid closes well
and the gaskets are un‐
damaged and clean.
Refer to "ActionFreeze
function".
Refer to "Opening and
closing the lid".
Position the water drain‐
age plug in the correct
way.
Refer to "Operation" chap‐
ter.
The compressor starts af‐
ter a period of time.
Refer to "ActionFreeze
function".
Set a higher/lower temper‐
ature.
59