Technical Data - Osmo HANDXCENTER Manuel D'instruction

7. Maintenance – Read the following information carefully!
When cleaning or maintaining the machine, or when replacing parts, the motor is to
>
be turned off and the power cable disconnected from the power outlet.
The power cable may not be run over, pinched, tugged or similarly abused or
>
damaged.
The power cable is to be inspected routinely for any signs of damage.
>
The machine must not be used if the power cable is not in a good condition.
>
For the use or replacement of power and machine cables, only the types stated by
>
manufacturer may be used.
When replacing the connectors for power or machine cables, splash protection and
>
mechanic durability must remain guaranteed.
If the hook and loop fastener is smooth, damaged or strongly discoloured, it should
>
be replaced to ensure that the machine runs properly.
Under no circumstances should highly flammable, combustible, toxic, hazardous,
>
corrosive or irritant substances be used.
Maintenance work may only be performed by approved customer service centres
>
or by specialists in this field who are familiar with all relevant safety regulations.

8. Technical data

AC electric motor: 230 V; 50 Hz
Sound pressure level: 75dB
Nominal power input: 120 W; 1.9 A
Number of rotations: 3100/min
Ø Hook and loop fastener disc: 240 mm
Working width: 218 mm
Weight: 2.4 kg
Protection class: I
Power cable length: 2 m
Technical modifications reserved.
The above mentioned information is provided to the best of our knowledge however
without any liability. (Version: 03/2020)
14