Colouring Wood With; Professional Color-Oil; Service - Osmo HANDXCENTER Manuel D'instruction

5. Colouring wood with Osmo Oil Stain, Wood Wax Finish,
Polyx -Oil Tints or Polyx
®
Apply a very thin coat of coloured oil
>
with Osmo Microfibre Roller, Osmo
Flat Brush or a cloth.
Immediately afterwards spread out
>
evenly with Osmo HandXcenter and
a white pad. Buff until uniform colour
distribution is achieved.
For difficult-to-reach areas like inside
>
corners, such as in drawers, Osmo
Hand Pad Holder with a white pad can be used as an alternative to pre-treat the
surface.
Attention: Streaking means there is too much product on the surface. Either turn the
pad over or run the pad over untreated wood until dry.
For intense colour, repeat the process a second time once the surface has
>
completely dried.
Clear top coat
To protect the pigments against wear, e.g. on tabletops, worktops, etc., one coat of
a clear Osmo Polyx
and product information.
More information on this subject can be found in Osmo brochures or on the Osmo
website at www.osmo.com.

6. Service

For repairs, please contact your local Osmo distributor or service centre.
>
Attention! This machine is only intended for use on flat surfaces.
>
®
-Oil or Osmo Spray-Wax is to be applied as directed on the label
®

Professional Color-Oil

13