Troubleshooting Guide - Hinkley 980016 Instructions D'installation

2. REMOTE PAIRING PROCESS
NOTE: This unit is eequipped with an automatic learn function. There
are no frequency switches on the receiver; the receiver unit will
automatically scan the frequency from the remote control if any
changes are made.
A. Install batteries included with the transmitter. (Fig. 3)
NOTE: To prevent damage to the transmitter, remove these
batteries if not used for long periods of time (months).
B. Select the desired frequency setting from the back of the remote
control transmitter. (Fig. 3) You change the frequency setting by
arranging the small switches numbered 1 through 4 in the up or
down position making 16 different frequencies or combinations
possible. Anytime you change the frequency for a fan you must
complete the pairing process as described above.
C. Restore power to the fan. Press and hold "
seconds and release. If optional light kit is installed, the light kit will
flash twice and the signal light on the handheld remote will come on
when the button is pressed. The fan has completed the pairing
process with the handheld remote and is ready for use.
D. The "O" and "D" dip switch: The "D" selection is the light
dimmable selection for LED light only. The "O" selection is for
light ON/OFF functionality only. (Fig. 1)
3. OPERATING TRANSMITTER:
A. Store the transmitter away from excess heat or humidity.
B. Operation buttons on the panel of the transmitter: (Fig. 4)
The "1, 2, 3, 4" buttons:
These four buttons are used to set the fan speed as follows:
1= Low speed 2= Medium speed 3= Medium High speed
4= High speed
The " " button:
This button turns the fan off.
The" " button:
For fans that use LED bulbs, select "D" in the dip switch, The "
button turns the upper light ON or OFF and also controls the
brightness setting. The "
OFF and also controls the brightness setting. Press and release the
button to turn the light ON or OFF. Press and hold the button to set
the desired brightness. The light button has an auto-resume, it will
stay at the same brightness as the last time it was turned off.
The " " button: Switches between summer mode and winter mode
fan directions.
YOUR REMOTE NOW HAS FULL CONTROL OF THE FAN AND
LIGHT.

4. TROUBLESHOOTING GUIDE

A. Fails to operate:
a. Power to the receiver?
b. Receiver wired correctly?
c. Light kit switch turned on?
d. Good battery in the transmitter?
B. Won't operate at distance:
If the signal is weak and fails to operate the fan from a distance less
than 30 feet, try repositioning the antenna wire inside the fan
canopy for better reception.
" button for about 5
" button turns the bottom light ON or
.
Receiver
ON
Transmitter
Fig. 3
ON
"
Fig. 4
NOTICE!
Your ceiling fan and light kit assembly must meet the following
requirements:
1. Do not use with solid state fans.
2. Electrical rating: 120V / 60 Hz
MAX. motor amps:1.0 A
MAX. light watts: 150 W
For Warranty Information please visit www.hinkley.com
ON
ON
Frequency switches
1
4
3
Dip switch
Transmitter
2