To Obtain The Best Results; Package Contents; Description Of The Product; Fitting The Battery In The Collar - Dogtek NoBark ELITE Guide D'utilisation

3
User's guide
Thank you for choosing this DOGTEK product.

To obtain the best results

The owner's involvement during the first use of the product
is a key factor in obtaining the best results.
Do not leave your dog unattended with the collar on until he is accustomed to wearing
it and you are satisfied that it is working correctly. You should ensure that the settings
(bark detection sensitivity / operating mode) are adjusted correctly for your dog.
Closely monitor your pet during the first few days of use.
When your dog is barking, let the collar operate without interference. Any interference on your
part could be taken as a sign of acknowledgment; consequently the barking would become an
effective mean to attract your attention.
As soon as your dog stops barking, congratulate him (but not excessively) by petting him,
verbally praising him, or giving him a small treat to encourage his good behavior.
Remember that barking can indicate some behavioral issue. This bark control collar will allow
you to minimize excessive barking.
w w w . D O G T E K . c o m

package conTenTs

- NoBark Elite collar fitted with a strap and short contact points
- Lithium 3-V CR2 battery
- magnetic key
- neon test lamp
- pair of long contact points
- this user's guide

DescripTion of The proDucT

fiTTing The baTTery in The collar

Proceed as follows:
- Unscrew the battery cover using a coin.
- Insert the battery paying attention to follow polarity indicated under the collar (see Diagram 1).
- Retighten the battery cover using a coin. A beep sound is emitted indicating the correct
installation of the battery. If you do not hear any beep sound when retightening the battery
cover, remove the battery immediately from its housing. Check the polarity before trying again.

acTivaTe/DeacTivaTe The collar

Activate: move the magnetic key towards the collar so that it comes into contact with the red
mark, hold for 1 second (See Diagram 3). A Beep sound will be emitted and the indicator light will
flash in red indicating that the collar has been switched on.
4