Radio System Corporation BARK CONTROL Manuel De L'utilisateur page 4

Correction Reduction Resistors
For dogs who may be too sensitive to the correction levels, a resistor can be
purchased through customer service to reduce the level of correction.
Trimming Collar
If you have excess collar and need to trim it, fit the collar around the dog's
neck and mark the appropriate length. Be sure to allow room for your dog's
growth. Cut the collar and seal the edge by using a match or lighter.
Placing the collar on your pet
Put the collar on your dog making sure the receiver is positioned at your pet's
throat.You should be able to place one finger between the probes and your
pet's skin.
DO make sure the probes touch skin, trim hair if necessary.
DO monitor your dog during initial use.
DON'T leave receiver collar on dog for extended periods of time.
DON'T allow dog to wear other collars or metal tags while wearing the Bark
Control Collar.
DON'T leave collar on too tight. Doing so can cause Pressure Necrosis,
a condition where the skin deteriorates. Check and clean your pet's neck
regularly. If a rash or sore forms, take the collar off for a few days. When
replacing the collar make sure it is not too tight and that your pet's neck is
clean.
4