Watching Television Programs; Information Display; Basic Operations - Oceanic OCEALED1919B2 Guide D'utilisation

VII - Watching Television Programs
MAKE SURE ALL THE EQUIPMENTS AND POWER CORD ARE CONNECTED PROPERLY AND THE
UNIT IS SET IN CORRECT MODE BEFORE KINDS OF OPERATIONS.
- Press POWER button on the unit or remote control to power ON the unit (indicator will glow green);
press it again to power OFF (standby mode) the unit (indicator will glow red).
- Press SOURCE button on the unit or remote control to switch the unit to DTV or ATV mode.
SELECT DESIRED PROGRAM
1. Press CH+ button to play next channel.
2. Press CH- button to play previous channel.
3. Press number buttons on remote control directly to select desired program.
NOTE: Press -/-- button repeatedly to switch the digit.
VOLUME CONTROL
- Press VOL+ or VOL- to adjust the level of current volume.
Available range: 0-100.
MUTE CONTROL
- Press MUTE button to mute the sound, press it again to turn on the sound.
SOURCE SETTING
- Press SOURCE button on the unit or remote control to display the input source list.
- Press UP or DOWN navigation button to select desired input source, then press OK button to confirm
selection.
Available options: DTV, ATV, YPbPr, SCART, AV, HDMI , USB.
MULTIAUDIO SETTING
- Press AUDIO button on remote control and use navigation buttons to select desired audio language.
NOTE: To enable this function, make sure that the channel you are viewing supports multi-audio
languages.

INFORMATION DISPLAY

- Press DISPLAY button on remote control to display information of current program.

BASIC OPERATIONS

EN-18