RISCO Group RWX35S Mode D'emploi page 7


In very dirty or dusty areas. Dirt and dust can collect in the measuring
chamber of the detector and cause it to become over-sensitive.
In addition, dirt and dust can block the openings to the measuring chamber
and prevent the detector from detecting smoke.
Installation
The smoke & heat detector must be assembled on the ceiling or, if necessary, on the wall.
The smoke & heat detector cannot be networked with other detectors.
Before installation, read the sections titled "Where to install your smoke & heat detector" and
"Where not to install your smoke & heat detector", in these operating instructions.
Installing the detector
1. Select the installation location.
2. Remove the plastic mounting bracket from the detector (see Figure 5).
Figure 5
3. Using the mounting holes as a template, secure the mounting bracket to the
mounting surface (see Figure 7).
Battery Compartment
Figure 6
Tamper
7
Figure 7