Testing The Detector - Risco Group Rwx35S Mode D'emploi

Testing the detector

To ensure that your detector is functioning correctly, test it once a week using the
following procedure:
1. Press the cover up firmly (see Figure 12). If the detector is functioning correctly, a fire
alarm is activated (see Visual / Audible Indicators) and an alert message is sent to the
system receiver.
2. Release pressure to restore the alarm activation.
NOTES:
1. It is recommended to press the center of the detector for the quick test results.
2. If you wish to perform a spray test, the spray must be at a distance of 20 cm away
from the detector. Press on the spray continuously for at least 5 seconds; the LED
will flash every second for 25 seconds followed by alarm activation.
Figure 12
NOTE: A short beep once every 30
seconds indicates that the test is
unsuccessful.
You must have the detector repaired
or replaced immediately.
11