Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
- « FrEquEnCY » message
ª
The control board cannot determine the frequency of
the mains supply.
Unplug the machine and wait for 5 minutes before
plugging it back in.
If this message remains on the screen, either get the
control board checked over or have it replaced.
TECHNICAL SPECIFICATIONS
In order to obtain good results when mincing meat,
grinding and kneading, we recommend you fill the
bowl no more than half-full.
• BOWL CAPACITIES
R 23 / Blixer
23 : 24 quarts
®
R 30 / Blixer
30 : 29 quarts
®
R 45 / Blixer
45 : 47 quarts
®
R 60 / Blixer
60 : 63 quarts
®
• WEIGHT (lbs)
Net
R 23/R 30
223
Blixer
®
23/Blixer
®
30 :
R 45
305
Blixer
45 :
®
R 60
331
Blixer
60 :
®
20
• INSTALLATION
ª
We recommend that you install your vertical
cutter-mixer on a flat, stable surface.
• NOISE LEVEL
The equivalent continuous sound pressure level when
running these appliances empty is less than 70 dB
(A).
These appliances are fitted with four interlocking
devices.
The machine can be started only if the following
conditions are achieved:
- The bowl is locked in the right angular position,
- The bowl and the motor are in vertical position,
- The lid is locked on its support in the correct
angular position,
- The lid is closed on the bowl.
Caution: Allow product circulation to stop before
opening the lid.
These models are also fitted with a thermal protec-
tion system (with automatic reset) which stops the
motor if it is overloaded. A red warning light signals
that the machine is becoming too hot and is about to
Gross
stop.
289
If this happens, wait until the appliance has cooled
down before switching it back on (the orange light
will switch off and the green lights will switch on
364
again).
390
W A R N I N G
The blades are extremely sharp.
Handle with care.
R E M E M B E R
Never tr y to override the locking and safety
systems.
Never insert a nonfood into the container where
the food is being processed.
SAFETY
Never push the ingredients down with your hand.
Do not overload the appliance.
See warranty first then;
Should your unit require service, check with
your distributor to see where local service is
available. If not or if you wish your unit to be
serviced at the factory, call for return instructions
and ship the unit prepaid to our factory address.
PH : 1-800-824-1646
Robot-Coupe USA, Inc
Service Department Repair
264 South Perkins Street
Ridgeland, MS 39157
For service in Canada contact the Robot-Coupe
USA factory for repair instructions.
SERVICE
Publicité
Table des Matières
