Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RX510
Operation
The following cleaning procedure will ensure that
you achieve the most beneficial results in the
shortest amount of time.
1. Surface preparation
Clear the working area and make sure that all
windows and doors are closed tightly. Make sure that
all plants and trees adjacent to the cleaning area are
protected by a drop cloth.
2. Initial high pressure rinse
The next step is to spray the cleaning surface
with water to clear off any dirt or grime that may
have collected on the surface. This will allow your
detergent to attack the dirt that has worked its way
into the cleaning surface. Before triggering the gun,
adjust the nozzle to a wide spray pattern and slowly
adjust to the desired spray pattern. This will help you
avoid applying too much pressure to the surface that
could cause damage.
3. Detergent application
Only use detergents formulated for pressure
washers. Test the detergent in an inconspicuous area
before use.
Follow the manufacturer's label directions for mixing
the correct concentrations of detergent to water.
1. Unscrew the top of detergent applicator and fill
with detergent.
2. Put the top of detergent applicator back on.
3. Remove lance from gun.
4. Attach detergent applicator to gun.
Attach applicator to gun
En
5. Apply the detergent so it thoroughly covers the
cleaning surface. Apply from bottom to top to
prevent the detergent from sliding down and
streaking.
6. Allow the detergent to remain on the surface for
a few minutes. This is a good time to use a brush
to lightly scrub heavily soiled areas. Never allow
detergent to dry on the cleaning surface.
7. Remove detergent applicator from gun and replace
with the lance.
8. Rinse detergent from surface.
9. Rinse the detergent applicator with clean water
following each use.
5. Final rinse
Make sure you thoroughly rinse the surface and that
all detergent has been removed.
6. Shut down
1. Make sure all detergent is flushed from the system.
2. Turn off the motor.
3. Turn off the water supply.
4. Trigger the gun to de-pressurise the system.
5. After each use, wipe all surfaces of the pressure
washer with a clean, damp cloth.
Looking After your Product
1. This pressure washer is not meant to pump hot
water. Never connect to a hot water supply.
2. Never operate the unit for more than one minute
without spraying water. This will cause a heat
build-up that can damage the pump.
3. Only use the nozzles supplied with the machine.
4. Never store the pressure washer outdoors or
where it could freeze. The pump will be seriously
damaged. Any components with water left inside
will also be damaged, e.g. the pressure gun.
5. Release the trigger when changing the spray
pattern. Failure to do so could result in damage.
6. Do not operate the pressure washer with the inlet
water screen removed. Be sure to keep the screen
clear of debris and sediment.
7. Make sure you clean the machine every three
months and inspect the filter and the nozzle prior
to every use, ensuring there is no debris that may
impair use.
© Wilks-USA
8
Publicité
Table des Matières
