Wilks USA RX510 Mode D'emploi page 6

RX510
WARNING: This is a double-insulated machine so two systems of insulation are provided instead of
grounding. No grounding means are provided for a double-insulated machine, nor should grounding
means be added to the machine. Servicing a double-insulated machine requires extreme care and
knowledge of the system. It should be done only by qualified service personnel. Replacement parts
for a double-insulated machine must be identical to the original parts.
WARNING: Do not use an inlet pressure that exceeds the operating pressure of any of the parts (hoses, fittings, etc).
Ensure all equipment and accessories are rated to withstand the maximum working pressure of the unit.
WARNING: Never spray flammable liquids or use the pressure washer in areas containing combustible dust, liquids
or vapours.
WARNING: Do not spray electrical apparatus and wiring.
WARNING: To ensure machine safety, please only use original spare parts (including nozzles) from the manufacturer
or approved by the manufacturer.
WARNING: Make sure the inlet water is maintained between 0.01MPa and 0.4MPa.
WARNING: If the mains cable is damaged it must be replaced by the manufacturer, or its service agent or similarly
qualified person to avoid a hazard or injury.
WARNING: Use only extension cords intended for outdoor use and that have an electrical rating equal to or more
than the rating of the machine. Examine the cord before using and replace it if damaged. Keep the cord away from
heat and sharp edges. It is recommended that you use a cord reel that keeps the socket at least 60mm above the
ground.
CAUTION: Keep the hose away from sharp objects. Bursting hoses may cause injury. Examine the hose regularly
and replace it if damaged. Do not attempt to repair a damaged hose.
• Never disconnect the high pressure outlet hose from the machine while the system is pressurised. To de-
pressurise machine, turn power and water supply off, then press gun trigger 2-3 times.
• Never operate the machine without all of the components properly connected to the machine (handle, gun / lance
assembly, nozzle, etc).
• Never operate the pressure washer with broken or missing parts. Check equipment regularly and repair or replace
worn or damaged parts immediately.
WARNING: To reduce the risk of electrocution, keep all connections dry and off the ground. Do
not touch the plug with wet hands.
WARNING: Do not use the machine if the supply cord or any important parts of the machine are
damaged (e.g. safety devices, high pressure hoses, etc).
En
© Wilks-USA
6