CampChef PG24MG Mode D'emploi page 8

HOPPER CLEAN-OUT KNOB ASSEMBLY INSTALLATION
Hand tighten the hopper clean-out knob as shown in Fig 14.
PG24-9 (1)
PULLOUT KNOB
Fig. 14
BURNER CLEAN-OUT
Before each use the burner should be cleaned out by lifting
the pullout lock and pulling the clean-out port knob on the
right side of the grill to open the burner clean-out. This will
allow the ash from previous use to fall into the cup under
the grill. The cup should be removed and emptied and then
reinstalled before each use.
Never Operate the Pellet grill without the ash cup in
place.
Make sure the burner clean-out port is closed and locked
before starting the grill.
Never open the burner clean-out port when the grill is
hot.
After cleaning out the burner make sure to close the burner
clean-out by pushing the clean-out port knob in on the right
side of the grill. Make sure to lift the pullout lock and push
the clean-out port knob all the way in and lock in place
with the pullout lock. Every 50 hours of use, remove the grill
grates, grease tray, and heat deflector and clean the inside of
the grill. If you notice a lot of ash blowing around in the grill it
is time to vacuum it out.
FILLING THE AUGER TUBE
CAUTION: ONLY USE THE FEED SETTING WHEN HOPPER HAS
RUN OUT OF PELLETS. FEED SETTING IS NOT FOR NORMAL
USE.
The first time you use your grill or any time the hopper has ran
DANGER
out of pellets you will need to fill the auger tube. This simply
means you must fill the auger tube with pellets until pellets
reach the burner. This is done by turning the dial to the FEED
position and then holding in the bypass button for 3 seconds.
This will turn the auger on and the digital readout will display
"FEED". The auger will remain on for no more than 7 minutes.
This is ample time for the pellets to reach the burner. It is
easiest to open the burner clean-out by pulling the knob on
the right side of the grill. Once you hear pellets dropping into
the cup you can close the clean-out port by pushing the knob
on the right side of the grill and then select your cooking
temperature. (Never operate grill without the ash cup in
place). Always make sure the burner clean-out port is closed
by pushing in the knob on the right side of the grill before
selecting any of the cook settings. Never open the burner
clean-out port when the grill is hot.
EMPTYING THE HOPPER
This grill is equipped with a hopper drain to quickly remove
the pellets from the hopper. This can be used to remove
pellets if the grill is being stored for a long time or to
remove pellets to change to a different flavor pellet.
Warning: Never remove the auger guard from the hopper
while the pellet grill is on. Never operate the grill without
the auger guard in place.
Caution: The instructions below must be followed when
emptying the hopper.
1. Unplug the grill from the power source.
2. Hang a bucket or use a box to catch the pellets that will
come out of the tube on the rear of the hopper.
3. Lift the pullout lock on the left side of the hopper and pull
CLEANOUT PORT KNOB
the hopper clean-out knob.
4. Sweep the remaining pellets in the hopper towards the
drain hole using the included rake to reach through the
guard.
5. Push in the hopper clean-out knob and lock in place
using the pullout lock.
6. Store the rake in the corner of the hopper as shown in Fig
15.