ohmex HET 4530 FIRE Manuel D'utilisation page 80

EN
• To avoid dangerous overheatings, to straighten the whole power cord and
to use the appliance as described in the "USE" paragraph is recommended.
• Do not leave the appliance unnecessarily inserted. Disconnect the plug
from the mains power supply when the appliance is not used.
• If the power cord of this appliance is damaged, it must be changed
exclusively by a technical assistance centre authorized by the manufacturer,
since special tools are necessary.
The electrical safety of this appliance is guaranteed only when
it is correctly connected to an effective grounding system as
specified by the current norms on electrical safety.
• It's necessary to check this fundamental safety condition and, in case of doubts,
ask for an accurate check of the system by professionally qualified personnel.
The manufacturer cannot be considered liable for possible damages
caused by the lack of grounding of the system.
• Before carrying out any operation turn off the appliance and disconnect the
power plug from the outlet and wait for the appliance to be completely cooled.
• Don't connect the appliance to the power supply through external timers
or remote control systems
☞
Keep the power cord away from the appliance hot parts.
• Do not let the power cord slide under carpets, etc.
• Do not cover the heater in order to avoid its overheating.
• There are no spare parts which can be replaced by the user inside the
appliance. Please refer to qualified technical personnel in case of need.
Do not lift the appliance by holding it from the frontal panel.
76
GENERAL WARNINGS
HET 4530 FIRE