Installation and Operating Instructions
CHAPTER 3
INSTALLATION
m
DANGER
ATTENTION
ATTENTION
NOTE
Condensate pump AIR1-KP
AIR1 XC 2200, 3200
3.0 Installation
The AIR1 unit must be fully isolated from the mains power supply before all main-
tenance and installation work and opening the terminal compartment! The electrical
connections must be carried out in accordance with the wiring diagrams and must only
be carried out by qualified electricians. The electrical connection must be fully isolated
until the final assembly!
Thoroughly rinse the condensate tray to remove all metallic particles and foreign objects
before connecting the condensate pump.
The pump should never be operated "dry" without water.
1. The condensate pump installation locations are shown in the following image (the AIR1 unit
has two condensate outlets for summer and winter operation), see Fig. 3.
If the condensate pump is used for summer conditions, the marked holder must be removed
and mounted on the other side as shown in the following image, see Fig. 4.
2. Connect the pump and float with a small hose, see Fig. 5.
17,8
41,6
104,5
Fig.3
3
Fig.4
78,1
Fig.4