Kress Robotik Mission NANO KR101E Notice Originale page 9

1
Keep it Sharp
WARNING: Before cleaning, adjusting, or replacing the blades, turn your Mission
and put on protective gloves.
WARNING: When fitting new blades, make sure you replace ALL the blades. Always use new
screws when fitting blades. This is important to ensure blade retention and balance the blade
turning disc. Failure to use new screws could cause serious injury.
The Mission NANO does not cut grass like other
TM
mowers. Its cutting blades are razor sharp on 4
edges and rotate in both directions for maximum
cutting capacity. Each blade of your Mission
has 4 cutting edges. The blade turning disc will
make forward and reverse rotation at random to
use 4 cutting edges and minimize the frequency of
replacing the blades. Each cutting blade will last up
to 3 months when it is programmed to mow every
day. Always check to see if the blades are chipped
or damaged and replace them if they are. When the
cutting blades are dull and worn out, they should be
replaced with the spare blades provided with your
Mission NANO. Spare blades are also available at
TM
your nearest Kress retailer.
A. Replace the blades
Usually your Mission NANO's blades need to be reversed each month and replaced each 2 months. When
TM
replacing the blades, make sure to replace all of them at the same time. You can replace them with one of the
spare blade kits and extra blade screws supplied with your Mission
Before attempting to replace your Mission
blades, turn the power off and put on protective
gloves and follow these steps:
1. Gently flip the Mission
2. Remove the battery cover and remove the
battery.
3. Take the screws off the blades with a
screwdriver.
4. Firmly screw on the new blades.
5. Refit the battery and the battery cover.
Important: After screwing the blade to the blade
disc, make sure the blade is able to spin freely.
2
Keep it Clean
WARNING: Before cleaning, turn your Mission
cleaning the blade turning disc and do not rinse or flush with water.
NANO
TM
NANO's
TM
NANO over.
TM
NANO.
TM
NANO OFF. Put on protective gloves before
TM
NANO OFF
TM
1
2
9
EN