Technical Data - Kemppi PROMIG 100 Manuel D'utilisation

8.

TECHNICAL DATA

Working voltage (safety voltage)
Rated power
Max. load of sub-feeder
(nominal values)
Max. load of intermediate cables
Air-cooled
Liquid-cooled
Operation principle
Diameter of feed roll
Wire feed speed I
Wire feed speed II
1)
Filler wires to be welded
Steel, solid wire
Steel, cored wire
Stainless steel
Aluminium
Gun adaptor
Operation temperature range
Storage temperature range
Degree of protection
The product meets conformity requirements for CE marking.
Dimensions of sub-feeder
Weight
Lengths of intermediate cables
Speed range is changed by changing the gear wheel of motor both in the Promig 100 sub-
1)
feeder and in the Promig 501, 501L and 530 wire feeder. In addition you must change the
place of the jumper block selection on circuit card A001 of the Promig 501, 501L and 530.
18 – Promig 100/0601
50 VDC
150 W
60 % ED 500 A
100 % ED 390 A
K 60 % ED 350 A
100 % ED 270 A
W 60 % ED 500 A
100 % ED 390 A
4 roll feed
32 mm
0...18m/min
0...25m/min
ø 0,8... 1,6 mm
ø 0,8... 1,6 mm
ø 0,8... 1,6 mm
ø 1,0... 1,6 mm
Euro adaptor
- 20...+ 40 °C
- 40...+ 60 ° C
IP 23
length 575 mm
width 185 mm
height 200 mm
8,9 kg
15 m and 25 m
©
KEMPPI OY