Service, Operation Disturbances; Ordering Numbers - Kemppi PROMIG 100 Manuel D'utilisation

6.

SERVICE, OPERATION DISTURBANCES

The amount of use and the working environment should be taken into consideration when
planning the frequency of maintenance of Promig.
Careful use and preventive maintenance will help to ensure trouble-free operation.
The following maintenance operations should be carried out at least every six months:
- The wear of the grooves of the feed rolls. Excessive wear of groo-
Check:
ves causes problems in wire feed.
- The wear of the wire guide tubes of wire feed. Badly worn feed
rolls and wire guide tubes should be discarded.
- The wire guide tube in the gun connector should be set as near
the feed rolls as possible, but not touching them and the wire must
follow a straight line from the end of the tube to the groove of
the feed roll.
- Reel brake adjustment
- Electric connections
* oxidized couplings must be cleaned
* loose couplings must be tightened
Clean dust and dirt from the equipment.
When using compressed air, always protect your eyes
with proper eye protection.
In case of problems contact the Kemppi works in Lahti, Finland or your Kemppi dealer.
7.

ORDERING NUMBERS

Promig 100
Promig 501
Promig 501L
Promig 530
Prosync 50
Pro 3200
Pro 4200
Pro 5200
Procool 10
Procool 30
P40
P30W
RMT10
R10
R20
5 /0,95 m
8 /1,5 m
16d/10 m
20 /5 m - 50 mm
20 /5m - 70 mm
21 /5 m - 50 mm
21 /5m - 70 mm
Hub for wire reel
©
KEMPPI OY
2
2
2
2
twice a
year
6236305
6231501
6232505
6232530
6263121
6131320
6131420
6131520
6262012
6262016
6185264
6185409
6185475
6185409
6185419
4269340
4269030
6185481
6184511
6184711
6184501
6184701
4289880
Promig 100/0601 – 17