Elpumps VB 20/800 Manuel Utilisateur page 24

GB
- In case of any irregularity during operation or placing out of service, remove the mains connection plug from
the connection socket.
- Any maintenance may be done only on the apparatus disconnected from the mains, with the connection plug
being removed from the socket.
- DO NOT operate the pump dry!
- DO NOT replace the mains connection cable of the device home. In case of failure of the connection cable, it
can be replaced only by the repair service shops listed in the list of Services, to the cable of the same quality
as the original one.
- Connect the mains connection plug to the mains in a dry place.
- DO NOT use the device with assembly connector plug.
- Any repair involving disassembly of the motor may exclusively be done by a technician or specialised repair
service shop! Following the repair, the pump should be subjected to tightness test. The completion of the
tightness test should be proven in writing by the technician or the specialized repair service shop performing
the repair.
- If extension cable is needed, use only extension cable of H07RN-F type of minimum 3x1.5 mm² cross section,
with a splash-proof connector.
- The voltage and current type indicated in the data plate should be the same as the data of the mains.
- For safety reasons, install a highly sensitive leak current protective switch (Fi relay 30mA DIN VDE 01100T739)!
Attention! This apparatus may be applied only in households, exclusively for domestic
purposes!
Prior to starting up the pump:
Check the integrity of the supply cable and the connection plug of the pump.
•
• Do not start the pump if it is failed. Make any repair performed only in a specialized repair service shop.
For lifting and transporting the pump, use the handle! Do not use the supply cable for removing the plug from
•
the socket!
DO NOT perform any change or modification on the apparatus arbitrarily!
Attention! Hot water may cause injuries!
If there is no liquid flow through the pump (the delivery side is closed, or there is air in the suction side) and
the pump is running for a long time (>10 minutes), then the water found in it may higly warm. Disconnect the
apparatus from the mains and let the pump and the water in it cool down.
Switch on the machine only if all faults are removed.
Contents
Chapter 1: General information
Chapter 2: Application limits
Chapter 3: Start-up, usage
Chapter 4: Technical data
Chapter 5: Maintenance, troubleshooting
Chapter 1: General information
The VB domestic waterworks have been developed mainly for ensuring the indoor water supply of family houses, bungalows,
such as toilet flushing, showers, washrooms, boilers. It is certainly suitable for performing further tasks as well, such as:
24