Flex BME 18.0-EC + LK 152 Notice D'instruction D'origine page 29

TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
Noise and vibration
NOTE
Values for the A rated noise level as well as
-
vibration total values can be gleaned from
the table "Technical data".
The noise and vibration values have been
determined in accordance with EN 60745.
WARNING!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given
in EN 60745 / EN 62841 and may be used
to compare one tool with another. It may be
used for a preliminary assessment of expo
sure. The declared vibration emission level
represents the main applications of the tool.
However, if the tool is used for different appli -
cations, with different cutting accessories or
poor maintenance, the vibration emission level
may differ. This may significantly increase the
exposure level over the total working period.
To make an accurate estimation of the vibra -
tion exposure level, it is also necessary to take
into account the times when the tool is
switched off or running but not actually in use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: tool and accessory maintenance, keep
hands warm, standard operating procedures.
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).
-
29