Flex BME 18.0-EC + LK 152 Notice D'instruction D'origine page 24

With the belt sanding attachment
BR 50, the power tool is designed
– for commercial use in industry and trade,
– for finishing stainless steel pipes, round
railing elements,
– for sanding/grinding round rod profiles
and also pipes in general,
– for use with sanding belts and accesso -
ries which are indicated in these instruc -
tions or recommended by the
manufacturer.
With the belt file sanding attachment
BF 140, the power tool is designed
– for commercial use in industry and trade,
– for sanding/grinding and polishing metal -
lic surfaces in areas with limited access
– for use with sanding belts and accesso -
ries which are indicated in these instruc -
tions or recommended by the
manufacturer.
Safety notices for power tool with fil -
let weld grinding attachment
WARNING!
Read all safety notices and instructions.
Failure to comply with the safety notices and
instructions may result in electric shock, fire
and/or serious injuries. Keep all safety
notices and instructions in a safe place for
future reference.
This power tool is to be used as a sander/

grinder. Observe all of the safety notices,
instructions, diagrams and specifications
included with the tool. Failure to heed the
following instructions may result in elec -
tric shock, fire and/or serious injury.
This power tool is not suitable for sanding

with sandpaper, working with wire brush -
es, polishing and cutting discs. Hazards
and injuries can ensue if the power tool is
not used in the way intended.
Do not use accessories other than those

specifically provided and recommended
by the manufacturer for this power tool.
Just because an accessory can be at -
tached to the power tool does not mean
that it is safe to use.
The approved speed of the tool/attach -

ment must be at least as high as the max -
imum speed specified on the power tool.
Accessories that rotate faster than permit -
24
TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
ted could disintegrate and broken parts
could fling off at speed.
The outside diameter and the thickness of

the tool/attachment must be within the ca -
pacity rating of the power tool. Tools/at -
tachments of the wrong size cannot be
shielded or controlled sufficiently.
Sanding/grinding discs, sanding wheels

or other accessories must fit precisely on
the grinding spindle of your power tool.
Tools/attachments that do not fit properly
on the spindle of the power tool will rotate
unevenly, vibrate heavily and cause loss
of control.
Do not use damaged tools/attachments.

Before each use, check tools/attach -
ments for chips and cracks, check sand -
ing/grinding plates for fractures and look
for signs of major wear and tear. If the
power tool or tool/attachment falls on the
ground, check whether it is damaged or
use an undamaged power tool and/or
tool/attachment. Once the tool/attach -
ment has been inspected and installed,
keep yourself and others away from the
rotating tool/attachment and allow the
power tool to operate at full speed for one
minute. If tools/attachments are damaged
they will usually break in this test period.
Wear personal protective equipment.

Wear a visor, eye protection or goggles
depending on use. If appropriate, wear a
dust mask, ear defenders, safety gloves
or special apron to protect against small
grinding particles and material fragments.
Eyes should be protected against foreign
bodies that are flung into the air during
various applications. Dust masks or respi -
rators must be capable of filtering out dust
generated during use. Hearing damage
could ensue if you are exposed to loud
noise for extended periods.
Make sure that others are kept a safe dis -

tance from your working area. All persons
who enter the working area are required
to wear personal protective equipment.
Fragments of the workpiece or broken
tools/attachments could be flung into the
air and cause injuries even outside the
immediate working area.