Castel XELLIP XEK-AUDIO-1B Fiche Technique page 15

AUDIO VIDEO IP KIT
Speaker installation
Attach the speaker with four M3 à M4 screw (as shown below). Be careful, do not tight the speaker on his gasket.
Respect the 3mm distance by placing braces/spacers (risk of speaker deformation during tightening).
Microphone installation
Mount the microphone support through a 16mm hole (as shown below). The microphone hole shall be placed facing
the ground to avoid any water accumulation inside.
BPs mounting
Mount push buttons inside a 16mm diameter holes (as shown below).
Indicating Led mounting
Mount indicating Led inside a 6mm diameter holes (as shown below).
Technical data sheet no. EN-604-0092C www.castel.fr
FR
EN
Page 15 / 20