Solvis Cala 254 Notice De Montage page 6

EN Cala 254 Horizontally Flat Roof Holders Installation Guide
4.5 Installation with Weights
Load distribution
Fig. 4: Load distribution at slope angle
CAUTION
Hazard due to overloading the building
• As the system (solar module + holder + weights)
has a significant weight load, always check the
structural calculations for the building bearing
the load before beginning installation.
Example for load distribution
Fig. 5: Example for load distribution
6
= 30°/ 45° / 60°
Loads
The loads can be made from any material. It is important
that they remain resistant to any type of wind load that
may occur for the duration of the collectors' life-
span.Higher loads are required for gravel loading. For more
informationen please refer to the Technical Sales (tel.
see Kap. „Information About These Instructions", p. 2).
MAL-C-FDS-W-A · Technische Änderungen vorbehalten · 30906-3a SOLVIS