Holmatro CT 5111 Mode D'emploi page 43

To enable better cutting in specific situations the spreading tips can be removed.
WARNING
Prevent operation of the tool when you remove or connect of accessoiries.
Avoid cutting with the blade tips only. (Fig. 16)
Refer to Fig. 10
• Push (A) and pull (B) the pin out untill it locks.
• Remove the spreading tips from the blades (C).
6.5 Squeezing
• Open the blades.
• Put the blade tips over the object to be squeezed.
• Put the load 25 mm from the end of the tips. Use full width of the tips.
• Close the blades.
CAUTION
Always use the spreading tips. Make sure the lock pins stay locked.
6.6 Spreading
CAUTION
Always use the spreading tips. Make sure the lock pins stay locked.
6.6.1 Initial opening is sufficient
• Close the blades completely.
• Put both blade tips between the parts to be spread.
• Put the load 25 mm from the end of the tips. Use full width of the tips.
• Force the parts apart by opening the blades.
6.6.2 Initial opening is insufficient
• Open the blades.
• Put one blade tip in the opening. Use full width of the tip.
• Close the blades until the material is clamped.
• Bend the clamped material out of the way.
• Repeat this procedure until there is sufficient space to place both blade tips.
• Force the parts apart by opening the blades.
6.6.3 No initial opening
• Use a different tool or accessory to make an opening.
• Continue with the steps above, depending on the opening created.
CT51** (RH)(ST)
All manuals and user guides at all-guides.com
916.001.554_003
EN
43