Switching On And Off; Blower Function - Craftsman 900.74547 Manuel D'utilisation

Gently tug on the cord to insure that it
is firmly retained in the trimmerʼs
handle. Plug the receptacle end of the
extension cord into the plug blades in
the trimmer.
OPERATING INSTRUCTIONS
WARNING: Always use proper eye
protection that conforms to ANSI Z87.1
(CAN/CSA Z94.3) while operating this
power tool.
CAUTION: Inspect area to be trimmed
and remove any wire, cord, or string-like
objects which could become entangled in
the rotating line or spool. Be particularly
careful to avoid any wire which might be
bent outwardly into the path of the tool,
such as barbs at the base of a chain link
fence.

SWITCHING ON AND OFF

• To switch the tool on, squeeze the
trigger lever.
• To switch the tool off, release the
trigger lever.
• With the unit on, angle unit and slowly
swing the trimmer side to side as shown
in figure 11.
11
• To operate as a maintenance edger,
unplug the unit from the power source.
Push the conversion button and rotate
the tube 180° as shown in figure 9.
The tool will lock in position. Gently pull
the wire edge guide down into place as
10
shown in figure 12 and position the
trimmer above the surface as shown in
figure 12.
12
• Return to the trimming position by
unplugging the unit from the power
source, pushing the conversion button
and rotating the tube back 180°. The
tool will lock in the trimmer position.
When using the tool return the wire
edge guide to the original position, out
of the way.

BLOWER FUNCTION

(FIGURE 13)
The air flow created by the motor funnels
up through the guard to provide a built-in
blower. This feature can be used to blow
grass clippings off of sidewalks and other
hard surface areas.