Craftsman 900.74547 Manuel D'utilisation page 5

ASSEMBLY INSTRUCTIONS
ASSEMBLY TOOLS REQUIRED (NOT
SUPPLIED):
- Phillips Screwdriver
ATTACHING THE TWO PIECE
GUARD
WARNING: UNPLUG THE TOOL
BEFORE ATTEMPTING TO ATTACH
THE GUARD. NEVER OPERATE TOOL
WITHOUT GUARD FIRMLY IN PLACE.
THE GUARD MUST ALWAYS BE ON
THE TOOL TO PROTECT THE USER.
• Remove the two guard sections from
the carton.
• Attach the first guard section with side
tab into the groove around the housing
as shown in figure 1. Align the hole in
the guard with the post on the trimmer
housing.
1
Tab
• Remove the screw from the second
guard section.
• Insert the top tab from the second
guard section into the first guard
section as shown in figure 2. NOTE:
The rib behind the tab should be
hooked over the rib of the first guard
section. (See inset figure 2).
2
Tab
Rib
• Insert the side tab from the first guard
section into the slot of the second guard
section until you hear them "snap"
together (figure 3).
3
Slot
Tab
3 /4
• Insert the inch (19mm) screw as
shown in figure 4 to complete the guard
assembly.
4
• Once the guard is installed, remove the
covering from the line cut-off blade, located
on the edge of the second guard section.
ATTACHING THE EDGE GUIDE
• Remove the edge guide from the carton.
• Insert one end of the guide into the hole
in the housing as shown in figure 5.
• Pull the other end of the guide over until
it slips in opposite hole in housing
(figure 6).
• Rotate guide back against housing as
shown in figure 7. NOTE: Guide should
lay flat flat to the plastic housing as
shown in the illustration.